CafeTran

Hello,

I noticed that recently the ability to remove a working language from the dashboard that was introduced with "CafeTran Espresso 2016 Ichiro - Update 18" after this post:

How to remove working language from Dashboard drop-down list

https://cafetran.freshdesk.com/support/discussions/topics/6000041387

is not there anymore.

By the way, I would also be interested in the same solution to be applied to project names in the drop down list, so that one can clean up the list from unnecessary items. 

After applying this update, I think the Vertical tabs divider and Vertical docking divider have been set on by default, which may not be a good default when working with the "vertical" Window layout 2. 

My bad, I confirm it's there, I must have forgotten how to do it and tried to right click on the drop-down list itself!

When I applied the update, and tried the option while using Window layout 2, the vertical option was applied, but if they are designed to switch to the horizontal option in that layout, then all good for me :-)

Thank you for your quick reply.

Also, "Show term information" is very nice.

Hi Igor,

Thanks for the update and improvements. 

I noticed a bit of a bug with my last project. I have short files (~20-30 segments), which fit entirely in the grid pane and longer files (100+ segments) that don't fit and "activate" the navigation arrows in the upper right corner. However, if I work on a short file and then switch to a longer file within the same work session, the arrows don't toggle back on and I can't navigate quickly except by clicking the small numbers associated with segments.

Similarly, when I load a long file first, the navigation arrows appear and remain even when a shorter file is then loaded. 

Igor,

Before this update I ticked the boxes I now framed in red and they remained ticked. Now I have to tick them every time. What do I do that they remain as last used?

Straight from Update 2 to Update 3. Everything worked fine with Update 2. Now I have to tick the boxes each time I open a project.

>Now I have to tick the boxes each time I open a project.

Same here, twice this morning.

If you open an existing CT project, all TMs should open because they're included in the xlf file.

H.

Woorden, 

Maybe they should, they just don't seem to know it. The only TM that opens and remains checked is Total Recall. The others have to be checked individually each time I open the project to work on it.

Great, it's working again :-)

It's the first time I'm doing this, so I'm not sure if the update caused it to not work as it should, or it's working as it should but I don't realize it - but I'm trying to merge two files together. Upon selecting merge on the top page and choosing the files I'm sent to the usual screen to work, however, when I choose "Join target segments" it also joins the source segments. This prevents me from getting rid of an empty block in the target area as it's combining the source one two in which I have to split it again... rinse and repeat.

Could you check into this for me? Thank you!

*as it's combining the source one, too.

Ugh... one two... one too... forgive me :p